Ubiquiti PowerBridge M3
The Ubiquiti PowerBridge is designed for high performance and durable carrier-class WiFi Bridge Solutions with real TCP/IP Troughput of up to 150MBps on high distances with low latency.
Robust outdoor design
The mechanical design provides complete weatherproof performance. Acitivity and signal strength LED's provided for installers. Enhanced RF and Ethernet ESD/Surge protection enables prolonged operation in harshest environments.
The integrated AirMAX Technology (AirMAX TDMA Protokoll) allows the NanoBridge to build up carrier-class Links with 150Mbps of real TCP/IP throughput and ranges up to 20km.
The power supplication of the PowerBridge is done by passive Power over Ethernet (PoE) technique. This method allows you to transmit the needed power for the PowerBridge through the Ethernet cable which is used to connect the PowerBridge to your network. You do not need to install any wired power cord. A PoE injector is included.
AirOS is the intuitive, versatile, highly developed Ubiquiti firmware technology. It is exceptionally intuitive and was designed to require no training to operate. Behind the user webinterface is a powerful firmware architecture which enables hi-performance networking. The AirOS Software has an integrated Linux-SDK. Additionally, the AirControl application allows operators to centrally manage 100's of devices.
|Product:||Ubiquiti Networks / PowerBridge5|
|Processor:||Atheros AR2313 SOC, MIPS 24KC, 400MHz|
|Memory:||64MB SDRAM, 8MB Flash|
|Netzwerkschnittstelle:||1 x 10/100 BASE-TX (Cat. 5, RJ-45)|
|WiFi Frequency:||3 GHz|
|TX Power:||max. 25dBm|
|RX Sensitivity:||min. -94dBm|
|Antenna:||integrated 20dBi MIMO directional Antenna|
|Beamwidth:||13.5° Horizontal - 13.5° Vertical|
|Max Power Consumption:||8 Watt|
|Power Supply:||24V, 1A
(PoE Injector Included)
|Dimensions:||44,5cm x 41,6cm x 3,4cm|
|Operating Temperature:||-30°C bis +80°C|
|Humidity:||5% bis 95% kondensierend|
Scope of delivery:
|1 x Ubiquiti PowerBridge M3|
|1 x Passiv Power-over-Ethernet Injector|